Initial Setup on a Serial Port Connection Managed Controller: This managed device will be managed by a Mobility Master. Standalone Controller: This is the only controller on the network. Select Standalone or Managed then click Continue. The initial window of the Mobility Controller Setup Wizard asks you to select one of the following deployment modes. On your PC or workstation, open a Web browser and connect to. Make sure that the managed device is not connected to any device on your network.Ĥ. Connect your PC or workstation to 0/0/1 port on the managed device.Ģ. Connect a PC or workstation to 0/0/1 port on the managed device, then enter this IP address into a supported Web browser to launch the Setup Wizard.ġ. The default IP address of the managed device is 172.16.0.254/24. A network protocol that enables a server to automatically assign an IP address to an IP-enabled device from a defined range of numbers configured for a given network. , or configured to have a static IP address on the 172.16.0.254/24 sub-network. The PC or workstation must either be configured to obtain its IP address using DHCP Dynamic Host Configuration Protocol. You can launch the setup wizard using any PC or workstation that can run a supported Web browser. You are here: Home > Getting Started > Getting Started > Initial Setup on a Serial Port Connection
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |